Installation Guide

7.) Ensure gate is square. Measure from top left corner to bottom right
corner and write down the measurement. Measure from top right corner
to bottom left corner and write down the measurement. Make sure
measurements are equal before installing screws into uprights.
8.) a.) Once gates are square mark screw locations. Make sure to use
measurements below to mark holes for screws.
b.) Privacy gates:
Make sure 4 screws are installed at the intersection of each rail and
upright on both sides of gate according to screw placement below.
A total of 32 screws will be installed.
c.) Lattice top, open picket and closed picket top gates:
On “Leg” side of aluminum “P” channel, install 2 screws into top rail
on both uprights. Install 4 screws into bottom and middle rails on
both uprights according to screw placements below.
On back sides of uprights, hinges will be installed on one side of the
top and bottom rails. On upright opposite hinges, install 2 screws
into top rail, 4 screws into middle and bottom rails. On upright
on same side as hinges, install 2 screws into middle rail. The hinge
screws will be used for top and bottom rails. A total of 32 screws will
be installed, not counting hinge screws.
For 7" rails use the following
measurement for screw placement:
For 5
1
⁄
1
⁄
1
2
⁄2⁄
" rails use the following
measurement for screw placement:
1
1
⁄
1
⁄
1
4
⁄4⁄
"
2
1
⁄
1
⁄
1
2
⁄2⁄
"
6
1
⁄
1
⁄
1
4
⁄4⁄
"
7"
3
⁄
3
⁄
3
4
⁄4⁄
"
1
1
⁄
1
⁄
1
4
⁄4⁄
"
2
1
⁄
1
⁄
1
2
⁄2⁄
"
4
3
⁄
3
⁄
3
4
⁄4⁄
"
5
1
⁄
1
⁄
1
2
⁄2⁄
"
3
⁄
3
⁄
3
4
⁄4⁄
"
5
“P” Channel
“Leg” Side
of Channel
Upright