Installation Guide

3
1
1
2
2
3
3
4
4
Mark the fence location using string and line stakes.
Dig post holes 10" in diameter to your specifi ed frost line, plus 6".
Use the Center to Center measurements of the fence model being installed for the
Center to Center Post Distance.
If a fence panel is being used that is less than the width of a full panel, or if
posts are being used other than 5" in width, measure the width of the panel
and add the width of one post, that will be the Center-to-Center post distance
of the holes.
Tip:
Do not pre-dig all post holes. To ensure proper post spacing install
post-panel-post-panel-etc.
Tip:
Plan gate placement, opening and hardware
clearance before intalling fencing.
If frost line exceeds 30" dig hole to the appropriate depth and then add
6" of gravel for post drainage. Add concrete according to manufacturers
instructions until a depth of 30" remains and let concrete set to create a footing.
Set post in hole ensuring it is plumb and level. Fill hole with concrete
according to manufacturers instructions. Make sure panel will be 2" above
ground, or check with local building codes on fence height requirements.
Go to step 5.
*If frost line does not exceed 30", put 6" of gravel into bottom of both holes
and insert posts. Add concrete to
fi rst
post hole according to manufacturers
instructions to top of hole. Ensure fi rst post is plumb and level. Let concrete
set making sure panel will be 2" above ground. Do not add concrete to second
hole until later in installation.
*Check local codes for frost line depth and regulations.
Center to Center Post Distance
2"
30"
*Frost
Line
6"
12"
Panel
Panel
Panel