Vinyl Fence Kits Assembly and Installation Instructions PLEASE READ OWNER'S MANUAL COMPLETELY BEFORE ASSEMBLING YOUR FENCE. ALL STATED SIZES ARE NOMINAL DIMENSIONS. 34106808BOM V2 11/13 Owner's Manual Version 2.0 Privacy Panels Full Privacy Lattice Top Open Top Scallop Picket Closed Top Open Top Straight Picket * Select styles available by retailer To register your product, please visit: www.barretteoutdoorliving.
Thank you for choosing the Barrette Outdoor Living Fence. Please read the instructions completely before assembling your fence. Retain manual and your dated sales slip for future reference and warranty claims. Before You Begin… Check your local zoning laws. • Local zoning laws and Home Owners Associations may regulate the location, style and height of your fence or even require a permit signoff beforehand.
1 Tip: Do not pre-dig all post holes. To ensure proper post spacing install post-panel-post-panel-etc. Mark the fence location using string and line stakes. 2 Dig post holes 10" in diameter to your specified frost line, plus 6". Use the Center to Center measurements of the fence model being installed for the Center to Center Post Distance.
5 7 When present or included, insert aluminum into bottom rail, then insert bottom rail into bottom post route hole of first post only. Panels with 7" rails do not require aluminum inserts. 6 Insert boards into bottom rail ensuring U-Channels are on both ends. Start from first installed post and work towards second post 8 Next, attach U-Channels to boards. For full privacy fences follow Step 8 for assembly. Insert the top rail into the first top hole post route then guide over top of boards.
9a For lattice top fences follow Step 9 for assembly. Add the lattice insert over the top of the lattice (May not be required for certain styles). Place into the middle rail followed by the top rail. 10 a For closed picket top fences follow Step 10 for assembly. Attach middle rail into left side of post route then guide rail over boards. 9b Finally, add the completed assembly into the route holes of the first post. Proceed to Step 12. 10 b Insert pickets down through middle rail.
10 c 11b Insert the top rail into post route holes of first post then guide rail over picket tops. Proceed to Step 12. Insert pickets down through top and middle rail. Note: Scalloped and Arched panels have pickets/boards that are numbered. Start from left side with the #1 picket/board first. 11a 12 For open top picket fences follow Step 11 for assembly. Attach middle rail into left side of post route only then guide rail over boards. Insert top rail into left post route holes of first post only.
13 Measure panel plus the dimensions from center of 2nd post to center of next and dig the third post hole accordingly. Repeat steps until completed. Center to Center 14 Apply glue on inside rim of post caps then attach to posts.
Transferable Limited Lifetime Warranty What is covered: Barrette Outdoor Living warrants vinyl and aluminum products to include; vinyl and aluminum fence, vinyl and aluminum railing and plastic lattice against defects or workmanship for as long as you own your home. Barrette Outdoor Living will at its option replace the product in question with new product of the same or equivalent value at no charge.