BOM-34106808 Privacy Vinyl Fence Kit INSTALLATION INSTRUCTIONS • English .............................................................................. 1 • Français ............................................................................ 10 • Español ............................................................................. 19 Read all instructions prior to installing product. Refer to manufacturers safety instructions when operating any tools.
WARNING: • Improper installation of this product can result in personal injury. Always wear safety goggles when cutting, drilling and assembling the product. • Incorrect installation may cause harm to the product or individual. • Check local building codes to determine pool-safe fencing options. NOTICE: • DO NOT attempt to assemble the kit if parts are missing or damaged. • DO NOT return the product to the store. For assistance or replacement parts call: 1-800-336-2383.
1. 2. Mark the fence location using string and line stakes (Fig. 1). Fig. 1 NOTE: Plan gate placement, opening and hardware clearance before installing fencing. Post Location: Fig. 2 Measure the width of the fence panel (X) plus the width of the post (Y). This is the common centerto-center measurement (unless there is a cut-down panel) for post hole location (Fig. 2). X Y Post Installation: Dig the first two post holes.
. When included in kit, place aluminum insert into bottom rail, then insert bottom rail into bottom post route hole of first post only (Fig. 5). Panels with 7" rails and 8x6 panels do not require aluminum inserts. Fig. 5 NOTE: 8x8 panels will use aluminum inserts in the middle rail. 5. Attach U-channels to two end boards (Fig. 6). NOTE: Attach U-Channel to "tongue" side of first board, and "groove" side of last board. U-Channel Fig. 6 First Board Last Board U-Channel 6. 7.
For Lattice Top Panels: Fig. 9 Top Rail a. Add the lattice insert over the top of the lattice (Fig. 9). Lattice Insert b. Place lattice into the middle rail followed by the top rail. c. Finally, add the completed top assembly into the route holes of the first post (Fig. 10). d. Proceed to Step 8. Middle Rail Lattice Fig. 10 For Closed Top Panels: Fig. 11 Pickets a. Insert pickets into middle rail (Fig 11). b. Guide top rail over picket tops (Fig. 12). c.
For Open Top Panels with Pickets: Fig. 14 a. Attach middle rail into left side of post route only then guide rail over boards. Insert top rail into left post route holes of first post only (Fig. 14). b. Insert pickets down through top and middle rail (Fig. 15). NOTE: Scalloped and Arched panels have pickets/ boards that are numbered. Start from left side with the #1 picket/board first. c. Proceed to Step 8. For 3-Rail (8' High) Privacy Panels: Fig. 15 Fig. 16 a.
8. 9. Insert the completed fence panel into the route holes of the second fence post. Plumb and level the post and add concrete according to manufacturers instructions to top of hole (Fig. 19). Apply glue on inside rim of post tops then attach to posts (Fig. 20). Repeat these steps until completed. Fig. 19 Fig.
Transferable Limited Lifetime Warranty What is covered: Barrette Outdoor Living warrants vinyl and aluminum products to include; vinyl and aluminum fence, vinyl and aluminum railing and plastic lattice against defects in materials or workmanship for as long as you own your home. Barrette Outdoor Living will at its option replace the product in question with new product of the same or equivalent value at no charge.
