Instructions / Assembly

5
Begin aligning the straps. The large strap is used for the
hinge side. Align the top and bottom holes and top edge
of the large strap to the two holes on the C-bracket.
Pre-drill with a
3
⁄
3
⁄
3
32
⁄32⁄
" bit then secure with 2 of the #8 x
3
⁄
3
⁄
3
4
⁄4⁄
"
screws. Repeat step for each corner (Fig. 9).
Align, mark and pre-drill the 3 remaining holes on the
large strap with a
3
⁄
3
⁄
3
32
⁄32⁄
" drill bit. Be sure to go through
the rail and through the inserted C-bracket from step 5.
Secure with three #8 x
3
⁄
3
⁄
3
4
⁄4⁄
" screws. Repeat this step for
each corner (Fig. 10)
Slide the upright into the C-bracket of the bottom rail,
ensuring the bottom C-bracket is  ush to the bottom
of the upright. Leave a minimum of
3
⁄
3
⁄
3
8
⁄8⁄
" of the upright
extending above the top C-bracket (Fig. 8).
C-bracket
Top of Upright
3
⁄
3
⁄
3
8
⁄8⁄
"
Fig. 8
C-bracket
Large Strap
Fig. 9
Fig. 10
Flip over the panel, align and attach the small straps
with one #8 x
3
⁄
3
⁄
3
4
⁄4⁄
" screw. Repeat until all small straps are
attached (Fig. 11).
Fig. 11
Small Strap
7
8
9
10