Installation Guide

verandadeck.com
Pre-drill the holes with a 1/8 in. bit, angling
slightly upward and inward to allow for
clearance from the rail once repositioned
for securing. NOTE: using extended drill
bits is recommended to prevent damage
to the rail, and allow a more perpendicular
driving angle.
Mark the location of the bracket holes.
After marking hole locations, remove top
rail and balusters. Pre-drill the holes with
a 1/8 in. bit, angling slightly upward and
inward to allow for clearance from the rail
once repositioned for securing. DO NOT
OVERTIGHTEN. Bracket shown for visual
reference only.
Secure the top bracket allowing 1/32 in.
– 1/16 in. from the end of the rail. Mark
locations of the holes and predrill using a
1/8 in. bit. Secure with supplied #10 x 1 in.
screws. DO NOT OVER TIGHTEN.
Insert all balusters into the bottom rail.
Reposition the top rail over the balusters,
and lower into place between the posts.
After the top rail is fully inserted, secure
using the supplied #10 x 2 in. screws. NOTE:
using extended drill bits is recommended
to prevent damage to the rail, and allow a
more perpendicular driving angle. DO NOT
OVERTIGHTEN.
6
10
11
7
12
Insert a baluster into the rst and last
baluster holes.
Carefully position the top rail between the
posts and lower onto the two balusters,
making sure to fully seat the balusters into
the top rail.
8
9
13
14
Complete the installation by gluing the
post cap in place using a quality exterior
adhesive.