User's Manual Part 1
Getting Started FloPoint
®
Elite Uroflow System
page 26 User’s Manual
NOTE: The installation kit is compatible with dry-wall construction. If the wall material
differs, an alternate mounting system must be used.
1. Attach the Mounting Template to the wall such that the bottom of the template is level
and 3 feet (914 cm) above the floor.
2. At each of the 4 marked locations, press the tip of the anchor into the drywall using a
#2 Phillips screwdriver. Drive anchor clockwise until anchor stops flush with the wall.
Insert the screw into the anchor. Tighten the screw leaving 1/4" of thread exposed on
which to hang the bracket.
3. Hang the bracket on the 4 screws and tighten the screws. The Mounting Bracket
should be held securely flush with the wall.
4. Measure the distance from the bracket to the outlet. On the FloCharger, wrap any
power cord in excess of that length on the cord-wrap recess underneath the
FloCharger. If necessary, use adhesive tape to keep the cord in place.
5. Mount the FloCharger on the 4 posts of the Mounting Bracket. Start by getting one
post into one charger foot, then place the other 3 feet on the posts. Push the
FloCharger down until it is fully seated on the posts.
6. Attach the correct prongs into the AC adapter. The FloPoint
®
Elite system is
compatible with power systems world-wide and a set of prongs for various systems
are included with the AC adapter. The prongs will click into place and be held
securely.
7. Plug the AC adapter into the socket. The FloCharger is now ready to charge. The
FloSensor and the ScanPoint
®
Remote should come from the factory already
charged. After the initial charge, recharge the batteries whenever they are low or
completely drained.
Step 3: Installing Adobe
®
Acrobat
®
Reader
ScanPoint
®
with QuickPrint uses Adobe Acrobat Reader (version 6.0 or higher) to print
labels and patient reports. If Acrobat Reader software is not already installed on your
computer, you can obtain a free copy at the Adobe Web site: http://www.adobe.com.
Follow the links for Acrobat Reader. After installing the Acrobat Reader software, you
must run the program once to accept the End User License Agreement in order to use
Acrobat Reader for printing reports.
Step 4: Install ScanPoint
®
with QuickPrint
IMPORTANT! You must have Administrator privileges to install ScanPoint
®
with
QuickPrint.
The dialog boxes displayed on your computer may differ slightly from
those illustrated in the following procedures. If so, follow the instructions
in the dialog boxes displayed on your screen.