User's Manual Part 1

FloPoint
®
Elite Uroflow System Getting Started
User’s Manual page 43
3. Remove the label spool.
4. Hold the spool spindle in your left hand and place the label roll on the spindle so
that the labels feed from underneath and the left edge of the label roll is flush
against the side of the spool (Figure 5).
Figure 5. Loading a Roll of Labels on the Spool Spindle
5. Place the spool guide onto the right side of the spool and press the guide tightly
against the label roll, leaving no gap between the roll and the spool.
NOTE: The roll of labels must fit snugly against both sides of the label spool, with
no gaps, so that the labels do not become misaligned as they feed through the
printer.
6. Align the left edge of the label with the left edge of the label feed slot and insert
the label into the slot (Figure 6).