User's Manual Part 2

FloPoint
®
Elite Uroflow System Cleaning and Maintenance
User’s Manual page 57
FloCharger Cleaning Procedure
1. Unplug the FloCharger AC adapter from the mains (wall outlet).
2. Remove the clamshell from the FloCharger base.
3. Dry any liquid remaining in the charging well.
4. Using a disinfecting wipe, clean all the surfaces of the FloCharger.
5. Replace the clamshell on the FloCharger base.
6. Plug the FloCharger back into the wall outlet.
ScanPoint
®
Remote Cleaning Procedure
To clean the Remote, use a germicidal wipe or a soft cloth dampened with IPA (70%
isopropyl alcohol) or an appropriate hospital cleaning agent, to wipe the surfaces of the
Remote until it is thoroughly cleaned.
Label Writer Cleaning and Maintenance
The ScanPoint
®
Label Writer is designed to give you long and trouble-free service, while
requiring very little maintenance. You’ll get the best possible performance from your
Label Writer if you follow the setup instructions that appear on page 39.
To keep your Label Writer printer working properly, you should clean it from time to time.
Dusting the outside of the printer occasionally will help keep foreign matter from getting
inside the printer. However, it is still a good idea to periodically perform some basic
interior maintenance.
You can easily clean your Label Writer printer using the following items:
 Lint-free cloth.
 Isopropyl alcohol, diluted dishwashing detergent, or diluted glass cleaner. (If you
use glass cleaner, make sure it does not contain ammonia.)
 Small, soft brush, such as a paint brush.
Cleaning the Exterior and Interior of Your Printer
1. Turn off the printer and disconnect the power cord.
2. Use the lint-free cloth to wipe the exterior of the printer. Remove dirt and
smudges with one of the cleaning solutions mentioned above.
3. Open the top cover.
4. Use a small, soft brush/cotton swab to whisk away paper dust and other stray
particles from the inside of the printer.
5. Remove the roll of labels to clean under the roll.
If you have a Label Writer cleaning card, follow the instructions printed on its
packaging and feed it through the printer mechanism.
6. Reconnect the power cord and turn on the printer.
7. Reload the roll of labels and close the top cover.