User's Manual Part 2

FloPoint
®
Elite Uroflow System Performing an Exam
User’s Manual page 51
Performing an Exam
Preparing for the Exam
Before you begin the exam:
1. Make sure you are familiar with the parts of the FloPoint
®
Elite system (see FloPoint
®
Elite Uroflow System Parts and Features on page 16).
2. Make sure you have performed all the steps in the setup procedure described in the
“Getting Started” which begins on page 20.
3. Check the Remote battery icon to make sure the battery has sufficient power.
NOTE: If the battery icon appears less than 25% full, return the Remote to the
ScanPoint
®
Docking Station until the battery is fully charged.
Performing an Exam
1. Pick up the Remote from the ScanPoint
®
Docking Station and a funnel and bring
both items to the restroom. Set both items on the counter while preparing the
FloSensor.
4. Place the funnel on top of the FloSensor.
Place the funnel on top of the FloSensor as shown in the
photo. Press the tabs on the funnel under the handles to
hold the funnel in place.
Put the seat down or leave it up depending on the
preference of the patient.
Remove and dispose of your gloves.
2. Prepare the FloSensor.
Put on a pair of gloves and lift the toilet seat.
Using the handles, remove the FloSensor from the
FloCharger clamshell. The FloSensor will beep and the
motor will start spinning.
3. Spread the handles and place the FloSensor in the toilet
bowl as shown in the photo.
Performing an Exam