User's Manual

Space
Start Menu
System Default
System Help
System Property
Tab
Undo
Undo Minimize All Windows
Universal Scroll
Universal Zoom
Up
Attention Please
1. Please don’t make the mouse far away from the receiver in order
to work more smoothly.
2. You’d better use the mouse on the white desk, in this way the
batteries can be used in a longer time. Please remove the
batteries if the mouse will not be used for a long time.
.3. This mouse with saving power sleeping functions, please press
any key or scroll the wheel to wake up the mouse when it is
sleeping.
4．If you want to take off the mouse power, please continue to press
the ID switch of the mouse bottom over 3 seconds. If you want to
take on the power, please click the ID switch once again.
Caution
Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority
to operate the equipment.
Note
FCC Statement:: 1.This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions:(1)This
device may not cause harmful interference, and(2)This device
must accept any interference received, including interference that
may cause undesired operation. 2.Changes or modifications not
expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and
receiver.
* Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician for
help.