Instructions

1906
USB-C™ Multiport Hub
QUICK INSTALL GUIDE
FCC Compliance
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WEEE Notice
The Directive on Waste Electrical and Electronic Equipment (WEEE), which
entered into force as European law on 13th February 2003, resulted in a
major change in the treatment of electrical equipment at end-of-life.
The WEEE logo (shown at the left) on the product or on
its box indicates that this product must not be disposed
of or dumped with your other household waste. For
more information about electronic and electrical waste
equipment disposal, recovery, and collection points, please
contact your local municipal household waste disposal
service or shop from where you purchased the equipment.
CE Declaration
Complied the requirements set out in the Council Directive on
the Approximation of the Laws of the Member States relating to
Electromagnetic Compatibility (2014/30/EC) and Low Voltage Protection
2006/95/EC.
This declaration applies to all specimens manufactured identical to the
model submitted for testing/evaluation.
EN 55032:2012+ AC:2013 (Class B)
EN 61000-3-2:2014
EN 61000-3-3:2013
AS/NZS CISPR 32:2013
EN 55024:2010
IEC 61000-4-2: 2008
IEC 61000-4-3: 2006+ A1:2007+ A2:2010
IEC 61000-4-4: 2013
IEC 61000-4-5: 2014
IEC 61000-4-6: 2013
IEC 61000-4-8: 2009
IEC 61000-4-11: 2004
RoHS Compliance
This product is in compliance with Directive 2011/65/EU of the
European Parliament and of the Council of 18 December 2006, on the
restriction of the use of certain hazardous substances in electrical and
electronic equipment (RoHS) and its amendments. Substances of Very
High Concern (SVHC) including 169 substances contained in Candidate
List of June 20th 2016 are not present in this product range above
permitted levels.
Verbatim_QIG_49142_90x65mm_1926.indd 1 25-06-19 14:22