User Guide

Wireless Travel Mouse with Stow-Away Receiver

User Manual

Product Features

1. Radio frequency 27MHz wireless transmission

2. Use of 256 ID codes to prevent interference between several wireless mice being used

simultaneously

3. Automatic power sleep function to extend battery life

4. Storage area for receiver in the mouse

System Compatibility

Win 95/98/Me/2000/XP

Macintosh 9.x, 10.x

Initial Set up

1. Turn the computer power on and log in

2. Connect wireless mouse receiver to USB port

3. Ensure batteries are installed in the mouse and mouse power is turned on (See

instructions below).

4. Hold mouse close to the receiver

5. Using a pen or other pointed device click the ID button on the receiver once, (See Figure

1 below). The red light will start to flash

6. Next, click the ID button on the underside of the mouse as indicated in Figure 1

Figure 1

7. The red light on the receiver will flash rapidly for a few seconds then stop flashing

PAGE 1
Wireless Travel Mouse with Stow-Away Receiver User Manual Product Features 1. Radio frequency 27MHz wireless transmission 2. Use of 256 ID codes to prevent interference between several wireless mice being used simultaneously 3. Automatic power sleep function to extend battery life 4. Storage area for receiver in the mouse System Compatibility Win 95/98/Me/2000/XP Macintosh 9.x, 10.x Initial Set up 1. Turn the computer power on and log in 2. Connect wireless mouse receiver to USB port 3.
PAGE 2
8. Now the mouse is ready for use Battery Installation 1. See Figure 2 below. 2. While pushing down on the area indicated push both sides of the cover off simultaneously. Figure 2 3. Insert 2 x AAA batteries as indicated 4. Replace the mouse cover over the batteries 5. To turn the mouse power on push the ID button, as indicated by Figure 3 below, for 3 seconds or more until the light comes on Figure 3 Receiver Storage 1. See Figure 4 below 2.
PAGE 3
Figure 4 Note: 1. Please remove the batteries if the mouse will not be used for an extended period of time 2. If the mouse has entered power sleep mode please press any mouse button or move the mouse to make it active again 3. To turn the mouse power off click on the ID button on the underside of the mouse for over 3 seconds until the light turns off 4.