User manual

Chapter 3 Function
3.1 Copy
When running the coping process, the data will really burn into the blank CD-R/RW discs. Before
starting the coping process, please make sure the master CD is put in the CD-ROM drive before
coping.
1. Copy
Place blank CD-R/CD-RW discs into the CD
writers. When all writers detect the CDs, press
“ENT” button, duplicator will start copying.
Copying-24X 0%
650.0MB 74:00 LCD will show the process of copying the disc.
1.Copy
OK: 03 When copying is completed, those discs passed will
be ejected automatically and failed ones will
remain in CD writers.
Put new CDs in the writers for additional copies.
NOTE: The CopySmartPlus is capable of CD-RW writing. Data stored in the CD-RW discs will be
quickly erased automatically before copying new data, no special setting or procedure is required
to erase the old data.
3.2 Test
This will simulate the CD-R/RW disc writing process. When testing is completed, the CD-R/RW
discs will remain blank.
2.Test
Press “ENT” button to start the disc copy simulation or
press “ESC” to exit.
Erasing disc
For CD-RW discs that contain data, emulate
will do quick erase of all old data before
emulation. Thus, never do emulate on CD-RW
discs that contain important data.
Testing-24X 0%
650.0MB 74:00 LCD will show the process of testing the discs.
2.Test
OK: 03
When the process is finished, the LCD will
show the message of the “Test” result.
Termination during Test will not affect the CD-R disc and they will remain blank. But please note
that CD-RW discs containing data will be destroyed and cannot be retrieved again. Some CD
writers may not support sudden termination during operation. The duplicator may hang up and
you can only reset those writers by re-starting the power.