User's Manual

38 39
SETBACK SETPOINTS / AUTO-RESTORE
00 When room is unoccupied and the thermostat is in the setback
mode or turned off, it will NOT maintain the temperature
between heat and cool setpoints;
When guest enters the room, the thermostat will be turned off -
it will not automatically restore the most recent guest settings;
01 When room is unoccupied and the thermostat is in the setback
mode or turned off, it will maintain the temperature between
heat and cool setpoints;
When guest enters the room, the thermostat will be turned off -
it will not automatically restore the most recent guest settings;
02 When room is unoccupied and the thermostat is in the setback
mode or turned off, it will NOT maintain the temperature
between heat and cool setpoints;
When guest enters the room, the thermostat will automatically
restore the most recent guest settings;
03 * When room is unoccupied and the thermostat is in the setback
mode or turned off, it will maintain the temperature between
heat and cool setpoints;
When guest enters the room, the thermostat will automatically
restore the most recent guest settings.
Set the “Conditional Control / Auto Restore” to “00”, to disable EMS.
Thermostat Settings
Thermostat is not controlling the PTAC unit.
Verify the status of the red light on the Wireless Control Card;
➤ The red light is off
The control card is not powered. Verify the Wireless Control Card is
properly wired to the PTAC unit;
➤ If the red light is blinking with one (1) flash
The Wireless Control Card is powered but it is not connected to the
thermostat, turn the thermostat off and on to re-initiate the linking
procedure.
➤ The red light is blinking with three (3) flashes.
The Wireless Control Card is connected to the thermostat - check
the wireless control card wiring and the thermostat configuration.
Troubleshooting