User`s guide

21-0375v4.2
Welcome Alarm
Status
Admin Reference
25
Checking the Status of a Suite
Security Unit (Condo)
(Suite Security/Multi-Tenant Keypad)
For systems that include Suite Security (multi-
tenant) keypads, the MONITOR ISM Director
software is required
to set up the system.
Due to the complexity of a typical Suite
Security installation, it is also recommended
that suite security status be checked only
through the software.
Each 'suite security' keypad pertains to an
individual multi-tenant suite or other self-
contained space. As such, arm/disarm
functions are provided only through the suite
security keypads themselves.
UL / ULC Listed Installations: Suite Security
LED keypads have not been tested for UL or
ULC listing.
Checking the Status or Controlling
an Elevator Reader
For systems that include elevators, the
"Status" menus will include an "Elev" selection
for elevators and their associated readers.
The available selections will be the same as
for standard readers
, as described in the
preceding section.
Attention: All floor status and control
functions are available only through the
MONITOR ISM Director software. As such, it
is recommended that all elevator reader status
and control tasks be performed through the
software as well.
Exception: Checking a specific aspect of an
elevator reader can be performed through the
keypad (such as checking if it is in Card Plus
PIN mode), but you will have to log in at an
operator workstation to see if the floors are
secure.
UL / ULC Listed Installations: UL and ULC
testing is pending on elevator (lift) controllers
and related features.
Checking the Status of an
Application Module (Printer)
You can check the status of any "application"
modules in the system. (An application
module provides increased functionality such
as Printer capability.)
Steps:
1. Enter your user ID
and/or PIN to log
into the keypad.
2. Select ► to
access other
functions.
3. Select Yes to
view status.
4. Select App to
view status of an
application
module.
5. Select Yes to
view the status of
the indicated
module (e.g. “HSC” for Printer), or use the ►
key to select another module.
6. Select HSC and
then Printer to
view the status of
the Printer.
The status screen will
indicate if the system
device is Ok or
disabled and any device related information.
Select Next to view status of the next module.
To return to the main screen (log out), press
the (8) key a few times, or let the system time-
out (1 minute).
Welcome
Enter ID: _ _ _
Push ► for menus
↓Stay ↓On
View Status?
↓Yes ↓No
Status of? ◄ ►
↓Points ↓App
ModuleName/Type ►
↓Yes ↓No
Pod Status . . . .
↓Printer
PRN(printer):OK
POD:OK
POD (definition): "Module" - a controller
that e.g. connects a Printer to the system.