User`s guide

50 MONITOR ISM™ LCD Keypad User's Guide 21-0375v4.2
LCD Error Messages
The following section contains a
comprehensive list of error messages that may
appear on the LCD user log on screen for
MONITOR ISM. The condition responsible for
each message is indicated below.
Power Failure: AC Failure.
System Trouble: Main Panel Tamper,
module Communications, module Substitution,
module Tamper, Fuse Trouble.
Battery Trouble: Panel or module battery low
voltage or missing/disconnected.
Phone Trouble: Phone Line Voltage Trouble.
Report Trouble: Digital Dialler
Communications Trouble.
Area in Test: Walk Test or Holdup Test In-
Progress.
Program Lost: Configuration Lost.
Program Error: Error in Configuration on
Main Panel, Error in Configuration on module.
HSC Comms: Alarm Communications
Trouble.
HH
∗ MM: Configuration communications in
progress (denoted by "*"). Times are normally
denoted by a colon (":").
If a trouble condition persists, contact your local
representative to service your system.
Trouble LED
The Trouble LED on
the LCD panel may
be activated when the following system
conditions occur:
System Tamper, Battery Trouble, AC Failure
(Flashing), Phone Line Trouble, Report Delay,
Time Lost, Time Changed, Program Error,
Fuse Trouble, module Trouble, module
Program Error, Misc. (Test Failure), HSC
Trouble.
System Status Trouble
The following conditions may appear when
viewing the system status:
System Tampr,
LoNoBattery,
AC Failure,
No PhoneLine,
Report Delay,
Time Lost,
Time Change,
Program Edit,
Prog Error,
Fuse(s) Fail,
Pod Trouble,
Pod Battery,
Pod ProgEdit,
Pod ProgErr,
HSC (alarm communications) Trouble
"POD" refers to a "module". (Point expander, door
controller, keypad, etc.).
If any of these trouble conditions persist, contact
your local representative to service your system.
Error Messages and Trouble Indications