DRYBACK LVT/LVP (LUXURY VINYL TILE/PLANK) INSTALLATION GUIDE Updated: 01-28-19 Note: This document supersedes all printed and electronic HOMs previously distributed for Verge Dryback LVT.
Product Description Dryback LVT/LVP Installation Method Glue Down INTRODUCTION This LVT product is a high-performance, glue-down flooring product, designed for permanent installations using the full-spread professional installation method, applied with a premium LVT adhesive. Good preparation, communication between all parties, and attention to detail when following instructions are key to a successful installation.
Product Description Dryback LVT/LVP CONCRETE SUBFLOORS GENERAL CONDITIONS All concrete floors, regardless of age or grade level must be properly cured, free of excess moisture, and prepared in accordance to the most current version of ASTM F710 (Standard Practice for Preparing Concrete Floors to Receive Resilient Flooring). Below and on-grade concrete subfloors must have a suitable vapor retarder properly installed beneath the slab (ASTM E1745).
Product Description Dryback LVT/LVP OLD CONCRETE Old or existing concrete subfloors may pose more of a risk than new concrete, therefore requiring special attention. Remove existing floor covering, all traces of old adhesives, paint, or other contaminants by scraping, sanding, grinding, shot-blasting or scarifying the substrate. The use of adhesive removers or solvents in the abatement or removal of existing or old adhesives is prohibited and may void the LVT warranty.
Product Description Dryback LVT/LVP NOTE: Various Federal, State, and Local government agencies have regulations governing the removal of in-place asbestoscontaining material. If you contemplate the removal of a resilient floor covering structure that contains (or is presumed to contain) asbestos, you must review and comply with all applicable regulations.
Product Description Dryback LVT/LVP ADHESIVES GENERAL INFORMATION: Areas of usage and subfloor conditions determine the appropriate adhesive. For areas with high point loads, rolling loads, topical spillages, radiant heat or direct sunlight only use Two Part Epoxy. Always use new trowels to ensure proper adhesive coverage.
Product Description Dryback LVT/LVP Pressure Sensitive (dry-to-touch) Applications: Lay tiles from the center of the room in a pyramid fashion while working towards the walls as shown in Figure 3. The dry, tacky adhesive makes it possible to work on top of the material without compromising the installation. Wet-Set Applications: The room layout must be set-up so that all flooring can be installed while working off of freshly installed tiles.
Product Description Dryback LVT/LVP MAINTENANCE PROCEDURES Safety: When performing wet maintenance, always use proper signage and prohibit traffic until the floor is completely dry. Always use caution and follow electrical equipment manufacturer’s safety instructions. NO-POLISHING/NO-BUFFING MAINTENANCE OPTIONS Initial Maintenance for a Newly Installed floor 1. Allow the adhesive to cure for at least 48 hours prior to wet-cleaning the floor. 2.
