Installation Instructions

Page 3 of 3
o Use two strips of duct tape to hold the sensor in place until the adhesive sets.
VM0481 Duct Tape, 2" Wide Gray 50 YD Roll
o Allow the adhesive to set overnight before putting the truck into service.
1.3 CONNECTIONS
The WDS is a wireless device and has no connections.
1.4 FCC
Per FCC 15.19(a)(3) and (a)(4) This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Per FCC 15.21, The user manual or instruction manual for an intentional or unintentional
radiator shall caution the user that changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to operate the
equipment.
To satisfy RF exposure requirements, this device and its antenna must operate with a
separation distance of at least 20 cm from all persons." Reference FCC KDB 784748,
Section A.8.