Owner's manual
Table Of Contents
- NURIT 8000
- Preface
- Overview
- Setup
- Specifications
- Maintenance and Cleaning
- Troubleshooting Guidelines
- NURIT 8000 Appears to Have No Power
- Transactions Cannot be Completed Successfully
- Wireless Communication Does Not Work
- Operation with Peripheral Device Not Successful
- Printer Does Not Print
- Printer Continues Printing When Out of Paper
- Magnetic Stripe Card Reader Does Not Function Properly
- Smart Card Reader Does Not Function Properly
- The Keypad Does Not Respond
- An Incorrect Response or Data Is Obtained
- “Tampered Device” Displayed On Screen and Keypad Inoperable
- Service and Support
- Index
- Contact VeriFone
SETUP
Installing SIM, SAM, and SD Cards
NURIT 8000 I
NSTALLATION GUIDE 15
To replace the battery
pack/card
compartment cover
1 Place the NURIT 8000 face down on a soft, smooth surface, so as not to
damage the LCD screen.
Figure 5 Replacing the Battery/Card Compartment Cover
2 Insert the two hinges of the battery/card compartment cover into the hinge
slots on the edge of the battery/card compartment.
3 Close the compartment cover and press down until the locking tab snaps into
place.
4 Connect the AC/DC power adapter from the electrical power outlet.
Installing SIM,
SAM, and SD
Cards
Configuration of SIM, SAM, and SD cards are model dependent. You can install
one SIM card, up to two SAM cards, and an SD card in the NURIT 8000 terminal,
depending on the particular model.
The card compartment is shared with the battery. To gain access to the battery/
card compartment, you must first remove the battery/card compartment door. For
information on removing and replacing the battery/card compartment door, see
Opening and Closing Battery/Card Compartment Cover.
To install a SIM or a
SAM card
1 Remove the battery/card compartment door. See Figure 4.
2 If necessary, remove the battery. See Figure 10.
3 Slide the locking-clasp in the direction indicated by the engraved arrow to the
OPEN position.
4 Lift the cardholder on its hinge to a vertical position.
5 Hold the SIM/SAM card vertically, with the beveled corner at the top edge and
the metallic contacts facing towards the contacts on the reader.
6 Slide the card into the cardholder.
NOTE
A SIM card must be installed when using a model of the NURIT 8000 that
implements GSM or GPRS wireless communications technology.
NOTE
Make sure that you first slide the end closest to the chip on the card into the
grooves of the holder and that the beveled corner is on the top edge of the SAM
card.