Owner's manual
Table Of Contents
- NURIT 8000
- Preface
- Overview
- Setup
- Specifications
- Maintenance and Cleaning
- Troubleshooting Guidelines
- NURIT 8000 Appears to Have No Power
- Transactions Cannot be Completed Successfully
- Wireless Communication Does Not Work
- Operation with Peripheral Device Not Successful
- Printer Does Not Print
- Printer Continues Printing When Out of Paper
- Magnetic Stripe Card Reader Does Not Function Properly
- Smart Card Reader Does Not Function Properly
- The Keypad Does Not Respond
- An Incorrect Response or Data Is Obtained
- “Tampered Device” Displayed On Screen and Keypad Inoperable
- Service and Support
- Index
- Contact VeriFone
SETUP
Using the Smart Card Reader
28 NURIT 8000 INSTALLATION GUIDE
Using the Smart
Card Reader
The EMV-compatible smart card reader is located at the bottom end of the NURIT
8000 terminal. Use the smart card reader with a smart card.
To use the smart card
reader
1 Hold the smart card horizontally, with the metal chip facing up and at the edge
of the card nearest to the smart card reader slot.
2 Insert the card into the smart card reader slot.
Figure 21 Inserting Smart Card
3 Remove the card when prompted by the POS terminal, depending on the
specific application being used.
NOTE
For guidance, a pictogram near the card slot indicates how to insert the smart
card into the smart card reader. In addition, insertion direction arrows may be
engraved or inscribed on the smart card.