User's Manual
Table Of Contents
- C680
- Contents
- Preface
- Terminal Overview
- Setup
- Terminal Location
- Inside the Shipping Carton
- Terminal Features
- Installing the SIM/SAM/Micro- SD Cards
- Connection Ports
- Installing the Paper Roll
- Power Supply
- Using the Battery
- Battery Behavior (No Power Pack)
- Charging the Battery
- Conducting Smart Card Transactions
- Using the Magnetic Card Reader
- Conducting a Contactless Transaction
- Periodic Inspection
- Specifications and Maintenance
- Verifone Service and Support
- Troubleshooting Guidelines
- Contact Verifone
SETUP
Installing the SIM/SAM/Micro-SD Cards
14 C680 INSTALLATION GUIDE
• An internal thermal printer at the top front of the terminal.
• A smart card reader, built into the bottom of the terminal. An icon indicates the
proper card position and insertion point.
• A SAM (Security Access Module) compartment, built into the bottom of the
terminal inside the back compartment.
Installing the
SIM/SAM/Micro-
SD Cards
You may need to install or replace a GSM SIM (Subscriber Identity Module) card,
one or two SAM (Security Access Module) cards, or a micro-SD card.
To Install or Replace a
SIM Card
1 Ensure that the terminal is turned off.
2 Place the terminal upside down on a soft, clean surface to protect the lens
from scratches.
3 Gently push the compartment cover’s locking mechanish to release. Lift and
remove the cover.
Figure 4 Remove Terminal Back Cover
4 Lift the battery pack.
5 Remove the card slot cover by pushing the movable side of of the terminal
with your finger or by using a screw driver to release.
Figure 5 Remove Card Slot Cover
A
B
NEPO
KCOL
A
B