User's Manual

SETUP
Power Supply
18 C680 INSTALLATION GUIDE
8 Close the paper roll cover by gently pressing directly on the cover until it clicks
shut, allowing a small amount of paper past the glue residue to extend outside
the printer door.
9 Tear the paper off against the serrated plastic strip in the printer.
Power Supply
After establishing all necessary connections, connect the power pack to the
terminal and into a wall outlet or powered surge protector to charge the battery for
six hours or until fully charged.
Each C680 terminal comes with power supply (VPN PWRXXX-001-XX-A) used to
connect the terminal directly to a power outlet and to charge the battery. The C680
unit comes with a universal input power pack capable of operating from voltages
of 100 V to 240 V AC.
Once it loads the application, the terminal starts the initial Verifone copyright
screen and displays a unique copyright screen. If there is no available application
in the terminal,
DOWNLOAD NEEDED appears on screen after the initial Verifone
copyright screen.
Using the
Battery
The C680 terminal uses a single cell Li-ion battery (see Accessories and
Documentation for ordering information). The internal logic of the battery prevents
both overcharging and undercharging (a fault condition in which the battery level
goes well below the minimum acceptable charge and the battery becomes
unusable).
CAUTION
To prevent damaging the print roller, always gently press down on the paper roll
cover to close it.
WARNING
Do not plug the power pack into an outdoor outlet or operate the terminal
outdoors. During a transaction, disconnecting the power by removing the battery
or unplugging the terminal from a wall power while at very low battery charge may
cause transaction data files not yet stored in the terminal memory to be lost.
NOTE
To protect against possible damage caused by lightning strikes and electrical
surges, consider installing a power surge protector.
NOTE
The C680 terminal will only operate when the battery is installed.