Installation Guide
Table Of Contents
- C680
- Contents
- Preface
- Terminal Overview
- Setup
- Terminal Location
- Inside the Shipping Carton
- Terminal Features
- Installing the SIM/SAM/R-UIM/ Micro-SD Cards
- Connection Ports
- Installing the Paper Roll
- Installing the Dongle
- Power Supply
- Using the Battery
- Battery Behavior (No Power Pack)
- Charging the Battery
- Conducting Smart Card Transactions
- Using the Magnetic Card Reader
- Conducting a Contactless Transaction
- Wireless Transactions
- Bluetooth Transactions
- 3G and CDMA Connectivity
- Dial-up/Ethernet Connectivity
- Periodic Inspection
- Specifications and Maintenance
- Verifone Service and Support
- Troubleshooting Guidelines
S
ETUP
Installing the Dongle
C680 I
NSTALLATION
G
UIDE
19
R
A
F
T
R
E
V
I
S
I
O
N
B
.
6
8
Close the paper roll cover by gently pressing directly on the cover until it clicks
shut, allowing a small amount of paper past the glue residue to extend outside
the printer door.
9
Tear the paper off against the serrated plastic strip in the printer.
Installing the
Dongle
C680 Dongle is supported in some countries. It provides dial-up/Ethernet
connectivity and offers USB and peripheral devices connection. It is shipped
together with a retrofitted terminal cover to accommodate the Dongle’s Y cable.
Figure 11 C680 Dongle
To install the Dongle:
1
Remove the terminal’s original back cover to access the ports.
2
Insert the Dongle’s micro-USB connector to the terminal’s micro-USB port and
connect the power barrel connector to the power port on the side of the
terminal.
Figure 12 Micro-USB and Power Connection
CAUTION
To prevent damaging the print roller, always gently press down on the paper roll
cover to close it.