Installation Guide
Table Of Contents
- C680
- Contents
- Preface
- Terminal Overview
- Setup
- Terminal Location
- Inside the Shipping Carton
- Terminal Features
- Installing the SIM/SAM/R-UIM/ Micro-SD Cards
- Connection Ports
- Installing the Paper Roll
- Installing the Dongle
- Power Supply
- Using the Battery
- Battery Behavior (No Power Pack)
- Charging the Battery
- Conducting Smart Card Transactions
- Using the Magnetic Card Reader
- Conducting a Contactless Transaction
- Wireless Transactions
- Bluetooth Transactions
- 3G and CDMA Connectivity
- Dial-up/Ethernet Connectivity
- Periodic Inspection
- Specifications and Maintenance
- Verifone Service and Support
- Troubleshooting Guidelines
S
ETUP
Power Supply
20
C680 I
NSTALLATION
G
UIDE
R
A
F
T
R
E
V
I
S
I
O
N
B
.
6
3
Replace the original cover with the new retrofitted cover and slide it back in
place to unexpose the ports. Screw to secure.
Figure 13 Replacing Old Cover with Retrofitted Cover To Close
4
Plug the power pack to the power outlet to prepare the Dongle for the
necessary connections (dial-up, LAN, peripheral device, and USB). See
Power Supply for more information.
Figure 14 Plugging the Dongle to the Power Outlet and Supported
Connections to the Dongle
Power Supply
After establishing all necessary connections, connect the power pack to the
terminal and into a wall outlet or powered surge protector to charge the battery for
six hours or until fully charged.
Each C680 terminal comes with power supply (VPN PWRXXX-001-XX-A) used to
connect the terminal directly to a power outlet and to charge the battery.
B
A
A
C
RS-232
A
B
WARNING
Do not plug the power pack into an outdoor outlet or operate the terminal
outdoors. During a transaction, disconnecting the power by removing the battery
or unplugging the terminal from a wall power while at very low battery charge may
cause transaction data files not yet stored in the terminal memory to be lost.