Installation Guide
Table Of Contents
- C680
- Contents
- Preface
- Terminal Overview
- Setup
- Terminal Location
- Inside the Shipping Carton
- Terminal Features
- Installing the SIM/SAM/R-UIM/ Micro-SD Cards
- Connection Ports
- Installing the Paper Roll
- Installing the Dongle
- Power Supply
- Using the Battery
- Battery Behavior (No Power Pack)
- Charging the Battery
- Conducting Smart Card Transactions
- Using the Magnetic Card Reader
- Conducting a Contactless Transaction
- Wireless Transactions
- Bluetooth Transactions
- 3G and CDMA Connectivity
- Dial-up/Ethernet Connectivity
- Periodic Inspection
- Specifications and Maintenance
- Verifone Service and Support
- Troubleshooting Guidelines
S
ETUP
Using the Battery
C680 I
NSTALLATION
G
UIDE
21
R
A
F
T
R
E
V
I
S
I
O
N
B
.
6
The C680 unit comes with a universal input power pack capable of operating from
voltages of 100 V to 240 V AC.
Once it loads the application, the terminal starts the initial Verifone copyright
screen and displays a unique copyright screen. If there is no available application
in the terminal,
DOWNLOAD NEEDED appears on screen after the initial Verifone
copyright screen.
Using the
Battery
The C680 terminal uses a single cell Li-ion battery (see Accessories and
Documentation for ordering information). The internal logic of the battery prevents
both overcharging and undercharging (a fault condition in which the battery level
goes well below the minimum acceptable charge and the battery becomes
unusable).
Battery Features
The following are features of the battery:
•
Single cell Li-ion 2450 mAH battery pack.
•
A safety circuit that:
•
Prevents cell damage from overcharge, over-discharge, or overheating.
•
Activates when the battery is left in an unused terminal for extended
periods.
NOTE
To protect against possible damage caused by lightning strikes and electrical
surges, consider installing a power surge protector.
NOTE
The C680 terminal will only operate when the battery is installed.
NOTE
•
C680 battery pack (PN BPK260-001-01-A) not customer changeable and
therefore should not be disconnected and removed.
•
Li-ion batteries are not affected by shallow charging. Furthermore, when the
terminal has no external power source or battery, the coin cell battery
provides power to the security circuit.
•
Disconnecting and removing the battery, as well as unplugging the terminal
power pack, reduce the life of the coin cell battery, which does not recharge
and must be replaced if drained.
•
Conserve battery power by turning the C680 terminal off when not in use.
Keep the Li-ion battery inserted in the terminal and power up the terminal
periodically to check the battery charge. Do not let the battery charge fall
below 10% for extended periods of time as this may permanently diminish the
battery capacity. Recharge the battery by attaching the micro-USB end of the
power pack to the terminal and plugging the other end of the power pack into
a wall outlet.