User's Manual
Table Of Contents
- Verifone Carbon Installation Guide
- Contents
- Preface
- Device Overview
- Setup
- Selecting Unit Location
- Unpacking the Shipping Carton
- Periodic Inspection
- Examining the Unit’s Features
- Establishing Communication
- Loading a Paper Roll in the Printer
- Installing or Replacing MSAM Cards
- Connecting Optional Devices
- Connecting the Terminal Power Pack
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Using the Contactless Reader
- Specifications
- Maintenance and Cleaning
- Service and Support
- Troubleshooting Guidelines
- Port Pinouts
- Appendix
- Contact Verifone
SETUP
Installing or Replacing MSAM Cards
V
ERIFONE CARBON INSTALLATION GUIDE 21
R
E
VI
SIO
N
A
.
2
7 Close the printer door by swinging upward until the door clicks shut, allowing a
small amount of paper past the glue residue to extend outside the printer door.
(see Figure 6).
Figure 6 Closing Printer Door
Installing or
Replacing MSAM
Cards
When you first receive your Verifone Carbon, you may need to install one or more
MSAM cards, or you may need to replace old cards.
To install or replace
MSAMs
1 Remove the power pack from the power outlet.
2 Place the unit upside down on a soft, clean surface to protect the display from
scratches.
NOTE
For paper ordering information, refer to Accessories and Documentation.
CAUTION
Observe standard precautions when handling electrostatically sensitive devices.
Electrostatic discharges can damage this equipment. Verifone recommends
using a grounded anti-static wrist strap.
NOTE
Verifone ships variants of the Verifone Carbon device for different markets. Your
unit may have different features described in this section.