Installation Guide

DEVICE SETUP
Charging the Battery
22 CARBON MOBILE 5 INSTALLATION GUIDE
2 Remove any partial roll of paper in the tray.
Figure 5 Steps to Install a Paper Roll in Verifone Carbon Mobile 5
3 Loosen the glued leading edge of the new paper roll or remove the protective
strip. Unwind the paper roll past any glue residue.
4 Hold the roll so the paper feeds from the top of the roll.
5 Pull the paper past the printer door.
6 Align the printer paper to the tabs to the paper guides and hold the paper up
when closing the door.
7 With the printer paper extending outside, close the printer door by swinging
upward until the door clicks shut, allowing the printer paper to extend outside
the printer door.
Charging the
Battery
After unpacking your Verifone Carbon Mobile 5 device, connect the power pack to
the unit for eight hours or until fully charged. Refer to the Using the Battery section
for more details.
Battery Life
Charging and discharging the battery will cause normal wear on the battery.
Using the Smart
Card Reader
Insert the smart card to proceed with the EMV transaction. EMV supports credit
card and debit card transactions.
To Conduct a Smart
Card T
ransaction
1 Position the smart card with the contacts facing upward (see illustration
below).
#
"
!
WARNING
Do not dispose batteries in a fire. Li-Polymer and Li-Ion batteries
must be recycled or disposed of properly. Do not dispose Li-ion
batteries in municipal waste sites.