Installation Guide

DEVICE SETUP
Installing or Replacing MSAM Cards
18 CARBON MOBILE 5 INSTALLATION GUIDE
Installing or
Replacing MSAM
Cards
When you first receive your Verifone Carbon Mobile 5, you may need to install one
or more MSAM cards, or you may need to replace old cards.
To Install or replace
MSAMs/MSIMs
FOR CM5
1 Turn off the Verifone Carbon Mobile 5 device.
2 Place the device face down on a soft, clean surface to protect the display from
scratches.
3 Remove the battery cover from the bottom and provide access to the MSAM card slot.
4 Remove any previously installed MSAM cards from the cardholder by pulling out the
MSAM in a horizontal direction.
5 Insert a MSAM card (with contacts face down) by carefully sliding it into the slot until the
card is fully inserted.
6 Make sure the card orientation is matching with the icon engraved in the housing.
7 Place the battery cover.
FOR CM5P
1 Turn off the Verifone Carbon Mobile 5 device.
2 Place the device face down on a soft, clean surface to protect the display from
scratches.
3 Remove the battery cover from the bottom corners.
4 Remove the primary battery from the battery compartment, but keep the battery
connected.
5 Remove any previously installed MSAM cards from the cardholder by pushing down on
the Nano-SIM icon (or actual Nano-SIM card) and pulling out the MSAM in horizontal
direction.
6 Insert a MSAM card (with contacts face down) by carefully sliding it into the slot until the
card is fully inserted.
7 Make sure the card orientation is matching with the icon engraved in the housing.
8 Place the primary battery.
9 Place battery cover.
CAUTION
Observe standard precautions when handling electrostatically sensitive devices.
Electrostatic discharges can damage this equipment. Verifone recommends
using a grounded anti-static wrist strap.
NOTE
Verifone ships variants of the Verifone Carbon Mobile 5 for different markets.
Your unit may have different options or accessories described in this section.