Installation Guide
Table Of Contents
- Carbon Mobile 5 Installation Guide
- Contents
- Preface
- Device Overview
- Device Setup
- Usage Guidelines
- Unpacking the Shipping Carton
- Examining Verifone Carbon Mobile 5 Device Features
- Installing or Replacing MSAM Cards
- Examining Connection Port
- Using the Battery
- Connecting the Terminal Power Pack
- Loading a Paper Roll in Device with Printer
- Charging the Battery
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Using the CTLS Reader
- Specifications
- Maintenance
- Verifone Service and Support
- Troubleshooting Guidelines
- Caution and Warning Messages
- Contact Verifone
DEVICE SETUP
Examining Connection Port
C
ARBON MOBILE 5 INSTALLATION GUIDE 19
Examining
Connection Port
The Verifone Carbon Mobile 5 device has one primary USB-C port used for power
and download.
Figure 3 The Verifone Carbon Mobile 5 Primary USB-C Port
Using the
Battery
The Verifone Carbon Mobile 5 device uses a single cell Li-Polymer battery or a
dual cell Li-Ion battery. The internal logic of the battery prevents both overcharging
and undercharging (a fault condition in which the battery level goes well below the
minimum acceptable charge and the battery becomes unusable).
Battery Features
The following are features of the battery:
• Single Li-Polymer cell for CM5 and two Li-Ion cells for CM5 printer.
• A safety circuit that:
• Prevents cell damage from overcharge, over-discharge, or overheating
• Activates when the battery is left in an unused device for extended periods
USB-C
USB-A
NOTE
• Charge the Verifone Carbon Mobile 5 device for eight hours before initial use.
• The Verifone Carbon Mobile 5 device comes with an extra battery that will
power the security circuit of the device in case, the device is tampered, and
the main battery fails to charge. This extra battery has a life of 1 year.
• Do not store the device for more than 1 week without charging, else the
secondary battery gets discharged in turn reducing the life of the battery.
• Disconnecting and unplugging the device power pack, reduces the life of the
coin cell battery, which does not recharge and must be replaced if drained.
• Conserve battery power by turning the Verifone Carbon Mobile 5 device off
when not in use. Do not let the battery charge fall below 10% for extended
periods of time as this may permanently diminish the battery capacity.
Recharge the battery by attaching the USB-C end of the power pack to the
device and plugging the other end of the power pack into a wall outlet.