Installation Guide
Table Of Contents
- E235 Installation Guide
- Contents
- Preface
- Device Overview
- Device Setup
- Terminal Location
- Inside the Shipping Carton
- Device Features
- Removing the Battery Cover
- Installing micro SIM and/or SAM Cards
- Initial Battery Charging
- Starting Up and Shutting Down
- Using the Battery
- Connecting to a Computer
- Conducting Wireless Transactions
- Using the Smart Card Reader
- Using the Magnetic Card Reader
- Using the CTLS Reader
- Using Accessories
- Specifications
- Maintenance and Cleaning
- Verifone Service and Support
- Troubleshooting Guidelines
- Caution and Warning Messages
- Contact Verifone
DEVICE SETUP
Removing the Battery Cover
E235 INSTALLATION GUIDE 15
Removing the
Battery Cover
Remove the battery cover to access the battery as well as the micro SIM and
micro SAM slots.
1 Turn off the device.
2 Place the device upside down on a soft, clean surface to protect the screen
from scratches.
3 If installed, loosen the retaining screw.
4 Slide the battery cover, away from the magnetic card reader.
Figure 3 Removing the Battery Cover
Installing micro
SIM and/or SAM
Cards
The e235 device supports the installation of two GSM SIMs (Subscriber Identity
Module) and/or SAM (Security Access Module). Use the following procedures to
install a SIM and/or SAM card.
1 Follow the steps in Removing the Battery Cover.
2 Insert the SIM and/or SAM card with the gold contacts facing down.
B
A
CAUTION
Observe standard precautions when handling electrostatically sensitive devices.
Electrostatic discharges can damage this equipment. Verifone recommends using
a grounded anti-static wrist strap.