Installation Guide

MAINTENANCE AND CLEANING
Surface Cleaning
24 E285 INSTALLATION GUIDE
Surface
Cleaning
To clean the device, use a clean cloth slightly damped with water and a drop or
two of mild soap. For stubborn stains, use alcohol or an alcohol-based cleaner.
Magnetic Card
Reader
Dirt accumulation can lead to MSR reading problems unless you clean the
Magnetic Stripe Reader (MSR) on a regular basis (daily to once a week,
depending on usage). Clean the MSR using commercially available card reader
cleaning cards or using recommended Verifone MSR-cleaning card (PN 02746-
02).
Smart Card Reader
Do not attempt to clean the Smart Card Reader (SCR). Doing so may void any
warranty. For smart card reader service, contact your Verifone distributor or
service provider.
Additional
Safety
Information
The following is additional safety information for using this device.
Power Adapter
Use only the power adapter that comes with your device. Adapters for other
electronic devices may look similar, but they may affect your device’s performance
or damage it.
Potentially
Explosive
Environments
Do not use this device in any area with a potentially explosive atmosphere. Follow
all signs and instructions. Potentially explosive atmospheres include areas where
you would normally be advised to turn off your vehicle engine. Sparks in such
areas could cause an explosion or fire resulting in bodily injury or even death.
CAUTION
Never use thinner, trichloroethylene, or ketone-based solvents – they can
deteriorate plastic or rubber parts.
Do not spray cleaners or other solutions directly onto the keypad or display.
NOTE
If using a commercially available cleaning card use ONLY an approved MSR
cleaning card made specifically for POS MSR Card reader terminals or
Petroleum MSR card readers.
CAUTION
If you find foreign objects in the SCR, send your terminal to a Verifone authorized
repair center.
Do not use Verifone’s recommended MSR-cleaning card (PN 02746-02) or
commercially available card reader cleaning cards with the SCR.