User's Manual

DEVICE SETUP
Using the Battery
14 E265G INSTALLATION GUIDE
V
E
R
I
F
O
N
E
C
O
N
F
I
DE
N
T
I
A
L
R
E
VIS
I
O
N
A
.
6
Using the
Battery
The e265G device uses a single cell Li-ion battery. The internal logic of the battery
prevents both overcharging and undercharging (a fault condition in which the
battery level goes well below the minimum acceptable charge and the battery
becomes unusable).
Battery Features
The following are features of the battery:
• Single Li-ion cell.
• A safety circuit that:
• Prevents cell damage from overcharge, over-discharge, or overheating.
• Activates when the battery is left in an unused device for extended
periods.
NOTE
The e265G device will only operate when the battery is installed.
NOTE
• The e265G battery pack is not customer changeable and therefore should not
be disconnected and removed.
• Li-ion batteries are not affected by shallow charging. Furthermore, when the
device has no external power source or battery, the coin cell battery provides
power to the security circuit.
• Disconnecting and removing the battery, as well as unplugging the device
power pack, reduce the life of the coin cell battery, which does not recharge
and must be replaced if drained.
• Conserve battery power by turning the e265G device off when not in use.
Keep the Li-ion battery inserted in the device and power up the device
periodically to check the battery charge. Do not let the battery charge fall
below 10% for extended periods of time as this may permanently diminish the
battery capacity. Recharge the battery by attaching the micro-USB end of the
power pack to the device and plugging the other end of the power pack into a
wall outlet.