Installation Guide
Table Of Contents
- e280 Installation Guide
- Contents
- Preface
- Device Overview
- Device Setup
- Specifications
- Maintenance
- Maintenance and Cleaning
- Verifone Service and Support
- Troubleshooting Guidelines
- Contact Verifone
DEVICE SETUP
Using the Battery
14 E280 INSTALLATION GUIDE
Using the
Battery
The e280 device uses a single cell Li-ion battery. The internal logic of the battery
prevents both overcharging and undercharging (a fault condition in which the
battery level goes well below the minimum acceptable charge and the battery
becomes unusable).
Battery Features
The following are features of the battery:
• Single Li-ion cell.
• A safety circuit that:
• Prevents cell damage from overcharge, over-discharge, or overheating.
• Activates when the battery is left in an unused device for extended
periods.
Battery Behavior
(No Power Pack)
The device shifts to power pack mode and starts up automatically when the e280
is connected to a non-battery power source, regardless of the battery charge
state.
Manual Startup
Hold the start button for about 10 seconds until the device displays the startup
screen.
Manual Shutdown
Hold the start button for about 10 seconds until the device is switched OFF.
NOTE
• Charge the e280 device for eight hours before initial use.
• The e280 device comes with an extra battery that will power the security
circuit of the device in case, the device is tampered and the main battery fails
to charge. This extra battery has a life of 2 yrs.
• Ensure not to store the device for more than 1 week without charging, else
the secondary battery gets discharged in turn reducing the life of the battery.
• Disconnecting and unplugging the device power pack, reduce the life of the
coin cell battery, which does not recharge and must be replaced if drained.
• Conserve battery power by turning the e280 device off when not in use. Do
not let the battery charge fall below 10% for extended periods of time as this
may permanently diminish the battery capacity. Recharge the battery by
attaching the USB-C end of the power pack to the device and plugging the
other end of the power pack into a wall outlet.
NOTE
Once the device is powered up, Verifone ADK MAC screen is displayed.
NOTE
The screen is blank when the device has no power.