Installation Guide

DEVICE SETUP
Connecting the Terminal Power Pack
E280 INSTALLATION GUIDE 15
Connecting the
Terminal Power
Pack
Connect the e280 device to the provided USB cable and insert the other end into
any USB charger head for initial charging.
Each e280 device comes with a power supply cable, USB to USB-C cable is used
to c
onnect the device directly to an USB outlet to charge the battery. The e280
unit is equipped with an USB capable universal input.
To Connect the
Terminal Power
Supply
1 Insert the USB-C plug into the USB-C port of the e280, as shown in the figure
below.
Figure 4 e280 Power Supply Connection
2 Plug the USB cable into a USB wall outlet or the output of a standard USB
power supply.
Charging the
Battery
After unpacking your e280 device, connect the power pack to the unit for eight
hours or until fully charged.
• Charge the e280 device for eight hours before initial use.
• The e280 device comes with an extra battery that will power the security
circuit of the device in case, the device is tampered and the main battery fails
to charge. This extra battery has a life of 2 yrs.
CAUTION
Using an incorrectly rated power supply may damage the device or cause it not
to work as specified. Before troubleshooting, ensure that the power supply being
used to power the device matches the requirements specified on the bottom of
the device. (See
Specifications for detailed power supply specifications.) You can
use any standard USB charger.
WARNING
Do not plug the power pack into an outdoor outlet or operate the device outdoors.
During a transaction, disconnecting the power by unplugging the device from a
wall power while at very low battery charge may cause transaction data files not
yet stored in the device memory to be lost.
USB-C
#
USB-A
USB-A
TIP
To protect against possible damage caused by lightning strikes and electrical
surges, consider installing a power surge protector.