Installation Guide

DEVICE SETUP
Using the Smart Card Reader
16 E280 INSTALLATION GUIDE
• Ensure not to store the device for more than 1 week without charging, else the
secondary battery gets discharged in turn reducing the life of the battery.
• Disconnecting and unplugging the device power pack, reduce the life of the
coin cell battery, which does not recharge and must be replaced if drained.
• Conserve battery power by turning the e280 device off when not in use. Do not
let the battery charge fall below 10% for extended periods of time as this may
permanently diminish the battery capacity. Recharge the battery by attaching
the USB-C end of the power pack to the device and plugging the other end of
the power pack into a wall outlet.
• The e280 device automatically shuts off when the battery reaches the critically
low charge state. If this occurs, the battery must be recharged for a minimum
of 1/2 hour before it can power the device. It may take several recharge
attempts to reset the safety circuit when charging a battery that has been
discharged below this critical state.
Battery Life
Charging and discharging the battery will cause normal wear on the battery.
Using the Smart
Card Reader
The insert the smart card to proceed with the EMV transaction. EMV supports
credit card and debit card transactions.
To Conduct a Smart
Card Transaction
1 Position the smart card with the contacts facing upward (see illustration
below).
2 Insert the card into the reader slot in a smooth, continuous motion until it seats
firmly.
3 Wait for the application to indicate a completed transaction before removing
the card. Premature card removal invalidates the transaction.
Figure 5 Inserting a Smart Card
WARNING
Do not dispose batteries in a fire. Li-ion batteries must be recycled
or disposed of properly. Do not dispose Li-ion batteries in
municipal waste sites.
