User's Manual

DEVICE SETUP
Connecting the Terminal Power Pack
E285 INSTALLATION GUIDE 15
Connecting the
Terminal Power
Pack
After installing the battery, connect the e285 device to the provided power pack for
initial charging.
Each e285 device comes with power supply (VPN PWR087-300-01-A) used to
connect the device directly to a power outlet and to charge the battery. The e285
unit comes with a universal input power pack capable of operating from voltages
of 100 V to 240 V AC.
To Connect the
Terminal Power
Supply
1 Insert the USB-C plug into the USB-C port of the e285, as shown in the figure
below.
Figure 7 e285 Power Supply Connection
2 Plug the AC power pack into a wall outlet or powered surge protector.
Once it loads the application, the device starts the initial Verifone copyright screen
and displays a unique copyright screen. If there is no available application in the
device,
DOWNLOAD NEEDED appears on screen after the initial Verifone copyright
screen.
Charging the
Battery
After unpacking your e285 device, connect the power pack to the unit for eight
hours or until fully charged.
CAUTION
Using an incorrectly rated power supply may damage the device or cause it not
to work as specified. Before troubleshooting, ensure that the power supply being
used to power the device matches the requirements specified on the bottom of
the device. (See
Specifications for detailed power supply specifications.) Obtain
the appropriately rated power supply before continuing with troubleshooting.
WARNING
Do not plug the power pack into an outdoor outlet or operate the device outdoors.
During a transaction, disconnecting the power by removing the battery or
unplugging the device from a wall power while at very low battery charge may
cause transaction data files not yet stored in the device memory to be lost.
IMAGE PLACEHOLDER
ACTUAL ILLUSTRATION TO FOLLOW
TIP
To protect against possible damage caused by lightning strikes and electrical
surges, consider installing a power surge protector.