User's Manual
Table Of Contents
- e315 Installation Guide
- Contents
- Preface
- Device Overview
- Device Setup
- Selecting a Location
- Unpacking the Shipping Carton
- Examining Device Features
- Installing/ Removing an iPod/iPhone into the e315
- Installing/ Replacing MSAM Cards
- Connecting the e315 to a Power Source
- Connecting the e315 to a Wall- mount Charger
- Connecting the e315 to a Host Computer via Micro-USB
- Battery Behavior (No Power Cable)
- Conducting Wireless Transactions
- Using a Smart Card to Conduct Transactions
- Using the Magnetic Stripe Reader
- Using the CTLS Reader
- Using the Barcode Reader
- Specifications
- Maintenance
- VeriFone Service and Support
- Troubleshooting Guidelines
- Contact VeriFone
DEVICE SETUP
Connecting the e315 to a Power Source
18 E315 INSTALLATION GUIDE
V
E
R
I
F
O N
E
C
O
N
F I
DE
N
T
I
A
L
R
E
VIS
I
ON
A.
6
Connecting the
e315 to a
Power Source
Plug the wall-mount charger to an external power source and connect it to the
e315 to charge the device.
The device operates in normal mode during startup or when in use. The device
enters p
ower saving mode when it has been idle for more than 60 seconds.
Connecting the
e315 to a Wall-
mount Charger
1 Plug the Apple-certified wall mount charger into a wall outlet or powered surge
protector.
2 Insert the micro-USB cable into the port located on the side of the e315.
Figure 7 Connecting the e315 to a Wall-mount Charger
NOTE
It is recommended to charge the e315 device for 8 hours before initial use. Do
not insert the iPod/iPhone during charging.
CAUTION
Using an incorrectly rated power supply may damage the device or cause it not to
work as specified. Before troubleshooting, ensure that the power supply being
used to power the device matches the requirements specified on the bottom of
the device. (See
Specifications for detailed power supply specifications.) Obtain
the appropriately rated power supply before continuing
with troubleshooting.