Installation Guide

SETUP
Micro SD Card
18 M400 INSTALLATION GUIDE
ICE Cubes
Ice Cubes are devices that offer economical, efficient, flexible, and specific
connectivity options. These modules are attached between a base module and an
end cap to meet specific customer requirements for different communications
interfaces.
The available module functions are provided below:
Base Module (PN 445-101-01-A)
Provides the interface to the M400 terminal through the USB type C connector in the rear
of the unit and the optional ICE cube modules. It has:
• Interface to the M400 terminal
• Power supply connection (12 V 1 A)
• Audio out connection (line level stereo)
• ICE cube connection bus to connect to additional cubes
USB Interface Module (PN 445-103-01-A)
This module has:
• ICE cube bus in
• ICE cube bus out
• RJ-50 with USB signals
Ethernet Interface Module (PN 445-104-01-A)
This module support 10/100 Mbits/sec and has:
• ICE cube bus in
• ICE cube bus out
• RJ-50 with Ethernet signals
Supported Configurations
The currently supported ICE cubes configurations are:
Micro SD Card
M400 supports micro SD for additional memory.
Insta
lling or
Replacing Micro SD
Card
To install or replace Micro SD card:
1 Turn off the terminal.
Configuration Type Part Number Description
USB CBL445-002-00-A Base Module + USB Module
2 USB Ports CBL445-003-00-A Base Module + USB Module + USB Module
Ethernet CBL445-006-00-A Base Module + Ethernet Module
Ethernet with USB CBL445-007-00-A Base Module + Ethernet Module + USB Module