User Manual
Table Of Contents
- M400
- Contents
- Preface
- Terminal Overview
- Setup
- Specifications
- Maintenance and Cleaning
- Service and Support
- Troubleshooting Guidelines
- Contact Verifone
SETUP
MSAM Card
M400 I
NSTALLATION GUIDE 23
MSAM Card
You may need to install one or two Multiple Security Access Module (MSAM)
cards or replace an old one.
Installing or
Replacing MSAM
Card
To install or replace MSAM cards:
1 Power off the terminal.
2 Place the terminal face down on a soft and clean surface.
3 Remove the cable cover of the unit.
4 Insert the SAM cards. Carefully slide the cards one at a time into the slots until
fully inserted.
Figure 15 SAM Insertion
To replace SAM card, gently slide out the old SAM card before inserting a new
one.
CAUTION
Observe standard precautions in handling electrostatically sensitive devices.
Electrostatic discharge can damage the equipment. Verifone recommends using
a grounded anti-static wrist strap.
NOTE
Position the card’s gold contacts facing upward toward the user. The card slot in
the terminal has a set of contacts. The MSAM card has a notch on one corner to
ensure that it fits into the connector base in only one way.