Installation Guide

SETUP
Device Power Source
M440 I
NSTALLATION GUIDE 21
Figure 7 MSAM Insertion
To replace SAM card, gently slide out the old SAM card before inserting a new
one.
Device Power
Source
The device is powered by an external AC/DC power pack. When you have
finished installing the necessary cards and/or optional devices, you are ready to
connect the device to the power source.
The device requires connection to a power outlet with a dedicated circuit or an
uninterruptible power supply (UPS). If other devices are plugged into the same
circuit, the device can potentially experience power fluctuations that might cause
malfunction. The device shuts down automatically once power source is removed.
Connecting M440
Device to a Power
Source
To connect M440 device to a power source:
1 Connect the Multiport cable (Example MSC445-010-00-A) to the Multiport at
the back of the device.
3!-
3!-
3!-
3!-
1
2
NOTE
Position the card’s gold contacts facing downward toward the user. The card slot
in the device has a set of contacts. The MSAM card has a notch on one corner to
ensure that it fits into the connector base in only one way.
WARNING
Do not connect the device to the power supply until all peripherals are attached.
Using an incorrectly rated power supply can damage the unit or cause it not to
work properly. Use only a power pack with P/N PWR445-001-1-A. See
Specifications for detailed power supply specifications.
Do not plug the power pack into an outdoor outlet or operate the device outdoors.
Disconnecting power during a transaction can also cause unsaved data files to
be lost.
NOTE
Verifone recommends installing a power surge protector to protect against
possible damage caused by lightning strikes and electrical surges.