User's Manual

DRAFT
MX 900 Series Installation Guide 21
March 1, 2012
Connecting to a Host PC
To connect the MX 900 Series terminal to a development PC, which shows a USB
connection with the 23741-02-R multiport cable. Note that USB drivers are
required to support this configuration.
Connecting to the Ethernet LAN
To connect the MX 900 Series terminal to an Ethernet LAN through the Ethernet
port using a standard Ethernet cable, insert the LAN cable from the LAN router
or hub into the Ethernet port on the multiport cable.
Connecting to USB Host or Hub
Connecting to a USB host or hub requires VeriFone USB cable (P/N 23741-02-R).
To connect to a USB host or hub:
1. Insert the multiport cable plug into the bottom socket on the terminal,
secure with the tie-down strap, and route the cable through the slots to
the desired exit side.
2. Plug the USB connector of the multiport cable into the USB host or hub.