User's Manual
Table Of Contents
- NURIT 8000
- Preface
- Overview
- Setup
- Specifications
- Maintenance and Cleaning
- Troubleshooting Guidelines
- NURIT 8000 Appears to Have No Power
- Transactions Cannot be Completed Successfully
- Wireless Communication Does Not Work
- Operation with Peripheral Device Not Successful
- Printer Does Not Print
- Printer Continues Printing When Out of Paper
- Magnetic Stripe Card Reader Does Not Function Properly
- Smart Card Reader Does Not Function Properly
- The Keypad Does Not Respond
- An Incorrect Response or Data Is Obtained
- “Tampered Device” Displayed On Screen and Keypad Inoperable
- Service and Support
- Index
SETUP
Power Supply
26 NURIT 8000 INSTALLATION GUIDE
D
R
A
F
T
R
E
V
I
S
I
O
N
A
.
3
Connect and route all cables between the NURIT 8000, ECR, and PC before
plugging the power pack cord into a wall outlet or surge protector.
Connect one end of the power adapter cable to the Power port on the bottom of
the terminal and the other into an electrical power outlet.
Figure 20 Power Supply Connection
WARNING
Use only the VeriFone supplied AC/DC power adapter to power the NURIT 8000.
The power adapter provides electrical power to the NURIT 8000 as follows:
• AC/DC adapter (safety approved)
Output: 9-10 V at 1 A
WARNING
Do not plug the power pack into an outdoor outlet or operate the NURIT 8000
outdoors. Also, disconnecting power during a transaction can cause transaction
data files not yet stored in memory to be lost.
NOTE
To protect against possible damage caused by lightning strikes and electrical
surges, VeriFone recommends installing a power surge protector.