User's Manual
Table Of Contents
- Wireless Palmtop Solution
- Foreword
- Table of Contents
- List of Figures
- 1. Product Regulatory Information
- 2. General Safety Instructions
- 3. Specifications
- 4. Initial Setup
- 5. Optional Accessories
- 6. General Features
- 7. Installing the Battery Pack
- 8. Connecting the NURIT 8000 to an AC Power Outlet
- 9. Installing the External Modem
- 10. Connecting the Car Adapter
- 11. Loading Paper in the Printer
- 12. Installing the Keypad Privacy Shield
- 13. Installing a SIM, SAM, or SD/MMC Card
- 14. Connecting Peripheral Devices
- 15. Connecting a Cellular Headset
- 16. Care and Maintenance
- 17. Troubleshooting
- Appendix A: Using the Magnetic Card Reader
- Appendix B: Using the Smart Card Reader
- Contact Information
Installation Manual 5
• Use only the power source as marked on the device. If you
are not sure of the type of the power supplied to your
location, consult your dealer or local power company.
• Do not overload wall outlets and extension cords as this
can result in the risk of fire or electric shock.
• Never push objects into the device through slots (other
than those specifically intended for the stylus, magnetic
stripe or smart cards, SAM/SIM cards, or SD/MMC card),
as this may result in fire or electric shock.
• To reduce the risk of electric shock, do not disassemble
any of the equipment or accessories referred to in this
manual. If required, take the equipment to a qualified
service representative. Opening or removing covers may
expose you to dangerous voltages or other risks. Incorrect
reassembly can cause electric shock.
• Take care when installing an internal battery pack. If
installed incorrectly, it may explode. Use only a Lipman
supplied battery pack. Discard used battery packs
according to local regulations.
• Disconnect the device from the power supply and any
peripherals and refer to qualified service personnel under
the following conditions:
• The power supply cable or plug is damaged or frayed.
• Liquid has been spilled into the device.
• The device has been exposed to rain or water.
• The device does not work normally, when following
the operating instructions.
• The device has been dropped or damaged.
• The device exhibits a distinct change in performance.
• When using the NURIT 8000 optional docking station and/
or external modem during thunderstorms, disconnect the
telephone line, if possible. There may be a remote risk of
electric shock from lightning.
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations unless the
jack is specifically designed for wet locations.
• Use caution when installing or modifying telephone lines.
• Never touch non-insulated telephone wires or equipment
unless the telephone line has been disconnected at the
network interface.