User's Manual
Table Of Contents
- Wireless Palmtop Solution
- Foreword
- Table of Contents
- List of Figures
- 1. Product Regulatory Information
- 2. General Safety Instructions
- 3. Specifications
- 4. Initial Setup
- 5. Optional Accessories
- 6. General Features
- 7. Installing the Battery Pack
- 8. Connecting the NURIT 8000 to an AC Power Outlet
- 9. Installing the External Modem
- 10. Connecting the Car Adapter
- 11. Loading Paper in the Printer
- 12. Installing the Keypad Privacy Shield
- 13. Installing a SIM, SAM, or SD/MMC Card
- 14. Connecting Peripheral Devices
- 15. Connecting a Cellular Headset
- 16. Care and Maintenance
- 17. Troubleshooting
- Appendix A: Using the Magnetic Card Reader
- Appendix B: Using the Smart Card Reader
- Contact Information
22 Installation Manual
10. Connecting the Car Adapter
You can use the Car Adapter to provide power to the
NURIT 8000 and to charge the installed Lithium-ion battery
pack.
To install the Car Adapter:
1. Connect the plug of the Car Adapter cable to the 3-pin
power jack on the front panel of the NURIT
8000.
2. Plug the car adapter into the vehicle's electrical power
socket.
Figure 10-1 Car Adapter Connection
To remove the Car Adapter:
1. Unplug the Car Adapter from the vehicle's electrical
power socket.
2. Unplug the Car Adapter battery charger cable from the
3-pin power jack on the front panel of the NURIT
8000.
Note
The LED indicator on the Car Adapter lights to
indicate the charge status of the battery pack,
as described in “Battery Pack Charge Status”
on page 20.