User's Manual

Installation Manual 23
11. Loading Paper in the Printer
The NURIT 8000 is equipped with an easy-load thermal printer.
To load a roll of thermal paper in the printer:
1. Place the terminal on a flat, stable surface.
2. Press the paper roll compartment cover release button in
the direction indicated by the displayed arrow.
3. Fully open the paper roll compartment cover.
4. Remove the paper roll spindle from the paper roll
5. Remove the tape strip from a new thermal paper roll.
6. Insert the paper roll spindle into the new paper roll.
7. Unroll approximately 5 cm (2 inches) of paper to facilitate
the loading process.
8. While holding the roll, place the spindle into the slots on
each side of the paper roll compartment.
9. Ensure that the paper roll feeds from the bottom.
Approximately 2.5 cm (1 inch) of paper should extend out
of the paper roll compartment between the cover and the
paper tear bar.
10. Close the paper roll compartment cover and press down
firmly until it snaps into place.
Figure 11-1 Loading Paper in the Printer



