User's Manual
Table Of Contents
- Wireless Palmtop Solution
- Foreword
- Table of Contents
- List of Figures
- 1. Product Regulatory Information
- 2. General Safety Instructions
- 3. Specifications
- 4. Initial Setup
- 5. Optional Accessories
- 6. General Features
- 7. Installing the Battery Pack
- 8. Connecting the NURIT 8000 to an AC Power Outlet
- 9. Installing the External Modem
- 10. Connecting the Car Adapter
- 11. Loading Paper in the Printer
- 12. Installing the Keypad Privacy Shield
- 13. Installing a SIM, SAM, or SD/MMC Card
- 14. Connecting Peripheral Devices
- 15. Connecting a Cellular Headset
- 16. Care and Maintenance
- 17. Troubleshooting
- Appendix A: Using the Magnetic Card Reader
- Appendix B: Using the Smart Card Reader
- Contact Information
24 Installation Manual
12. Installing the Keypad Privacy Shield
To install the keypad privacy shield:
1. Place the terminal on a flat, stable surface, or hold it
securely in one hand.
2. Position the tabs on the inner front sides of the keypad
privacy shield over the indentations on each side of the
terminal.
3. Press down the keypad privacy shield until it snaps into
place.
Figure 12-1 Keypad Privacy Shield Installation
To remove the keypad privacy shield:
1. Place the terminal on a flat, stable surface, or hold it
securely in one hand.
2. Grasp the keypad privacy shield and pull it away from the
terminal.
Note
Failing to install or removing the keypad privacy
shield may render the terminal non-compliant
with ISO 9564 for PIN protection and may
violate card association requirements for PIN
Entry Devices.