User's Manual
Table Of Contents
- Wireless Palmtop Solution
- Foreword
- Table of Contents
- List of Figures
- 1. Product Regulatory Information
- 2. General Safety Instructions
- 3. Specifications
- 4. Initial Setup
- 5. Optional Accessories
- 6. General Features
- 7. Installing the Battery Pack
- 8. Connecting the NURIT 8000 to an AC Power Outlet
- 9. Installing the External Modem
- 10. Connecting the Car Adapter
- 11. Loading Paper in the Printer
- 12. Installing the Keypad Privacy Shield
- 13. Installing a SIM, SAM, or SD/MMC Card
- 14. Connecting Peripheral Devices
- 15. Connecting a Cellular Headset
- 16. Care and Maintenance
- 17. Troubleshooting
- Appendix A: Using the Magnetic Card Reader
- Appendix B: Using the Smart Card Reader
- Contact Information
Installation Manual 27
Installing SIM and SAM Cards in the
Electronic
Cards Compartment:
To Install SIM and SAM cards:
1. Remove the battery pack from the terminal, as described
in
“Installing the Battery Pack” on page 18.
2. Remove the electronic cards compartment cover, if it is in
place.
3. Slide the cardholder locking-clasp in the direction
indicated by the engraved arrow to the OPEN position.
Figure 13-2 SIM/SAM Cardholder Locking-Clasp
4. Lift the cardholder on its hinge to an upright position.
5. Hold the SAM or SIM card so that its chip side is facing
down towards the contacts on the reader.
6. Insert the end closest to the chip on the SAM or SIM card
into the cardholder.
Note
In models that have an accessible TEL SIM slot,
it should always be used to install the SIM card,
as described on page 28.