User's Manual
Table Of Contents
- Wireless Palmtop Solution
- Foreword
- Table of Contents
- List of Figures
- 1. Product Regulatory Information
- 2. General Safety Instructions
- 3. Specifications
- 4. Initial Setup
- 5. Optional Accessories
- 6. General Features
- 7. Installing the Battery Pack
- 8. Connecting the NURIT 8000 to an AC Power Outlet
- 9. Installing the External Modem
- 10. Connecting the Car Adapter
- 11. Loading Paper in the Printer
- 12. Installing the Keypad Privacy Shield
- 13. Installing a SIM, SAM, or SD/MMC Card
- 14. Connecting Peripheral Devices
- 15. Connecting a Cellular Headset
- 16. Care and Maintenance
- 17. Troubleshooting
- Appendix A: Using the Magnetic Card Reader
- Appendix B: Using the Smart Card Reader
- Contact Information
Installation Manual 31
Figure 13-8 Inserting the SD/MMC Card
6. If required, replace or install the electronic cards
compartment cover. See
“Installing the Electronic Cards
Compartment Cover” on page 31.
7. Replace the battery pack, as described in “Installing the
Battery Pack” on page 18.
Installing the Electronic Cards Compartment
Cover
After installing the SIM, SAM, and/or SD/MMC card(s), you can
cover the electronic cards compartment with the supplied
plastic cover. You can also protect this cover from being opened
by sticking the included void label over the cutout in the cover.
To install the electronic cards compartment cover:
1. Remove the battery pack from the terminal, as described
in
“Installing the Battery Pack” on page 18.
2. Insert the two square tabs at the top of the plastic cover
beneath the upper wall of the electronic cards
compartment.
3. Press down on the bottom of the cover until the two tabs
snap into place under the lower wall of the electronic
cards compartment.