User's Manual
Table Of Contents
- Wireless Palmtop Solution
- Foreword
- Table of Contents
- List of Figures
- 1. Product Regulatory Information
- 2. General Safety Instructions
- 3. Specifications
- 4. Initial Setup
- 5. Optional Accessories
- 6. General Features
- 7. Installing the Battery Pack
- 8. Connecting the NURIT 8000 to an AC Power Outlet
- 9. Installing the External Modem
- 10. Connecting the Car Adapter
- 11. Loading Paper in the Printer
- 12. Installing the Keypad Privacy Shield
- 13. Installing a SIM, SAM, or SD/MMC Card
- 14. Connecting Peripheral Devices
- 15. Connecting a Cellular Headset
- 16. Care and Maintenance
- 17. Troubleshooting
- Appendix A: Using the Magnetic Card Reader
- Appendix B: Using the Smart Card Reader
- Contact Information
Installation Manual 41
The printer continues to operate when out of paper
1. Verify that the paper sensor of the printer mechanism (inside the
paper roll compartment) is not blocked by paper or debris.
2. If the problem persists, contact an authorized service
representative.
The magnetic card reader does not function properly
1. Verify that the card has been swiped with its magnetic stripe at
the bottom and facing the user. See Figure A-1 “Magnetic Card
Reader” on page 42.
2. Swipe the magnetic card in the opposite direction.
3. If possible, try using a different magnetic card.
4. If the problem persists, contact an authorized service
representative.
The smart card reader does not function properly
1. Verify that the chip end of the smart card is fully inserted with
chip side up. See Figure B-1 “Smart Card Reader” on page 43.
2. If possible, try using a different smart card.
3. If the problem persists, contact an authorized service
representative.